1 x Laser Head and Control Module

1 x Safety Goggles, adjustable (red)

1 x Connecting Cable, about 12cm

1 x Connecting Cable, 150cm

1 x Laser Alignment Spacer : 20mm

2 x T-Nut M3 x 10mm

2 x Hexagon socket screw M3 x 6mm

1 x 12V DC/5A Power Supply

1 xThree plug American standard cable

1 xU Disk

Dimension： 90mm * 33mm * 33mm

Light Color： Blue-violet

Input Voltage： DC12V

Wavelength： 445nm

Laser Output Power： 5500mW

1.Our 5.5W blue diode laser with a wavelength of 445nm. In order
to ensure sufficient cooling, the laser is mounted in a heat sink, which is additionally equipped with a powerful yet quiet cooling
fan.

2.The laser has a fixed focus with a focal length of 20mm, The
Laser Head is connected to the laser control unit by cables of
about 30cm length.

3.The plugs which fit into the Laser Control module are different to ensure correct connections to the cooling fan and the Laser Diode.

Powerful in engraving and carving, provide a neat and clear image Able to engrave wood, paper, lastic, leather, and moreQuick heat dissipation and lower voice

Safe and easy to assemble

The height of the Laser Alignment Spacer : 20 mm

Warnings!

•You must be at least 13 years old to operate the laser engraver.

•Direct exposure to the laser beam can cause severe burns and eye damage. Ensure that you are awake

proper laser safety goggles when working in the vicinity of the laser equipment.

•When you focus the laser do so only on the lowest power setting.

•Keep a fire extinguisher nearby since use of the laser may lead to an unexpected fire.

•Never leave an operating laser unattended.

•Fumes and smoke generated during the engraving/cutting process must be extracted from the room

can be poisonous; make sure there is a ventilated system to the outdoors.

•Make sure the cutting area under the laser is metal or non-flammable.

•Ensure that the room or area you are operating the laser in is sufficiently labeled to prevent someone from unknowingly walking into an active work area.

•Be sure to disconnect the power when cleaning, maintaining or servicing the laser equipment.

•DO NOT stare at the bright and intense light appearing during the engraving process. Doing socan cause serious eye damage.

•Never use the laser except for the purpose intended.