Description

Brand Name: MLHJ
Origin: CN(Origin)
Certification: CE
Model Number: UB500-18GM75-U-V1
Type: Ultrasonic Proximity Sensor
Place of Origin: Zhejiang, China
Brand Name: Winston
Usage: Position Sensor, Position Sensor
Theory: Ultrasonic Sensor, Ultrasonic Sensor
Output: Switching Transducer, Switching Transducer
Description: Ultrasonic Proximity Sensor
Transducer frequency: About 380kHz
Weight: 25g
Protection grade: IP67
Ambient temperature: -25…70℃(248…343K)
Operating voltage: 0…30VDC
Name: Ultrasonic Proximity Sensor

UB500-18GM75-U-V1 IP67 10VDC Digital Ultrasonic Proximity Sensor

Technique parameter

Technical data

General Specifications

Sensing distance 30…500mm

Adjustment range 50…500mm

Unusable area 0…30mm

Standard target plate 100mm×100mm

Transducer frequency About 380 kHz

Response delay About 50ms

Indicators/Operating means

LED blue Power on

LED yellow indication of the switching

state Flashing:program

function object detected

LED red permanently red: Error Red,

flashing:program function,

object not detected

Electrical specifications

Operating voltage UB 10…30VDC,ripple10%ss

No-load supply current ≤45mA

Output

Output type 1 analogue output 0…10V

Resolution 0.11mm at max.sensing range

Deviation of the characteristic

curve ±1% of full-scale value

Repeat accuracy ±0.1% of full-scale value

Load impedance >1k Ohm

Temperature influence ±1.5% of full-scale value

Ambient conditions

Ambient temperature -25…70°C

Storage temperature -40…85°C

Mechanical specifications

Protection grade IP67

Connection Connector M12x1,4-PIN

Material

Housing brass,nickel-plated

Transducer epoxy resin/hollow glass

sphere mixture; Polyurethane foam

Overall dimensions

Specifications

Product Description

External synchronization

The sensor can be synchronised by the external application of a square wave voltage. A synchronisation pulse at the synchronisation input starts a measuring cycle. The pulse must have a duration greater than 100 μs. The measuring cycle starts with the falling edge of a synchronisation pulse. A low level > 1 s or an open synchronisation input will result in the normal operation of the sensor. A high level at the synchronisation input disables the sensor. Two operating modes are available:

1. Multiple sensors can be controlled by the same synchronisation signal. The sensors are synchronised.
2. The synchronisation pulses are sent cyclically to individual sensors. The sensors operate in multiplex mode.

Internal synchronization

The synchronisation connections of up to 5 sensors capable of internal synchronisation are connected to one another. When power is applied, these sensors will operate in multiplex mode. The response delay increases according to the number of sensors to be synchronised. Synchronisation cannot be performed during TEACH-IN and vice versa. The sensors must be operated in an unsynchronised manner to teach the evaluation limits.

Note:
If the option for synchronisation is not used, the synchronisation input has to be connected to ground (0V) or the sensor has to
be operated via a V1 cable connector (4-pin).

Installation conditions
If the sensor is installed at the environment temperature fall below 0℃,It should do well on the protective measures. In case of direct mounting of the sensor in a through hole using the steel nuts, it has to be fixed at the middle of the housing thread.

Packaging & Shipping