Description

Product Overview
1. High-quality beam, Reliable performance, and Best
modulation efficiency.
2. Light, convenient, easy to integrate
3. Laser:445nm,≥1400mW

Technical Parameters

Item	Project	Parameters
1	Laser Classification	Class 4
2	TTL output power	>1K HZ Output power at work=Continuous power x 40%
3	Output stability	±5%
4	Beam Mode	Long strip light spot
5	Focus spot size	~0.2*0.6mm
6	Focus length	3~10cm
7	Lens material	Professional focusing optical glass
8	Powerboard input voltage	DC12V/DC24V
9	LD Input voltage	5V
10	LD Input Current	1.4A
11	Modulation mode	TTL
12	TTL trigger mode	Active high(>DC 2.0V)
13	Working frequency	<30KHz
14	Analog control input voltage	DC 0–5.0V
15	Ambient temp	-15℃–50℃
16	Preheating time	<1 Min
17	Working life	10000 Hours
18	Product weight	100g

Product Size

Electrical parameters

Item	Project	Technical parameters
1	Input voltage	DC 12V/DC 24V
2	Input power	7W
3	Output current	LD<2A
4	Constant current accuracy	Output current stability less than 1%, Output ripple is less than 100mV
5	Drive and power connection	22#AWG
6	TTL input maximum voltage	DC 5V
7	TTL input response voltage	DC2.0V

Product Wiring Diagram

 

Why Choose Us?

1. Laser Module adjustable focus laser head, can work continuously without cooling.
2. Optical power: 1600mW, higher power realizes better engraving and cutting, has faster engraving and cutting efficiency, and saves time.
3. Electric Power: 7W, can control the laser beam more accurately, suitable for cutting and dismantling materials with greater hardness, can engrave or cut designated engraving materials, and have a wide range of materials.
4. Adjustable focal length, safe engraving distance, no need to worry about the safety hazards of laser.
5. High-precision control of the laser beam, more stable and continuous output power, long service life, and average service life of up to 8000 hours.

Precautions

1.Not only plugged or unplugged under power is prohibited, but also avoids the effects of the tightness of the terminal by an external force. Otherwise, the laser will be damaged. Besides, the corresponding operator must wear a wired electrostatic bracelet.

2.The power supply itself has no key switch, and the power panel and the input line are exposed, When the laser connects or removes the circuit, it must operate under the condition of power off, in order to prevent the electric shock.

3. It is necessary to ensure that the temperature of the shell of the laser head is close to that of the suitable operating temperature before the laser can be turned on, so as to avoid the excessive temperature difference, which may affect the performance of the laser or damage the device.

4.The product shall be used in a dry, clean, and non – static environment with working temperature of 15 – 50 ℃ to avoid high temperature, high humidity and violent vibration and impact.

5.Do not arbitrarily adjust the potentiometer on the power supply board to avoid excessive current, circuit board, or laser burn.

6.Please do a good job of external heat dissipation measures, as far as possible to maintain the shell heat cooling air path and module cooling air path consistent, lest the temperature is too high, affect or damage the laser.

7.This product power supply for DC-12V does not connect to other power sources, lest damage the laser.

8.The laser has potential harm to the human body and the eyes, It is forbidden to use a laser to irradiate others, especially in the eyes.