modname=ckeditor

High speed infrared photodetector/photodiode

 

 

1 Imported Hamamatsu infrared photodiode is adopted

 

2 Diode type：InGaAs

 

 

4 Maximum response frequency：1GHz

 

5 Output voltage range：0V-12V（The supply voltage is12VTime）

 

6 The output impedance inside the detector is1MOhm，If users need to obtain appropriate response speed，A suitable resistor must be connected in parallel at the output。To maximize the response frequency of the detector，Its output must be connected in parallel50Ohm-100Ohmic resistance（Generally, it can be connected in parallel50Ohmic terminal，Bandwidth is greater than or equal to300MHzThe oscilloscope itself also has50Ohmic impedance selection）。The smaller the resistance of the output in parallel，The higher the peak power of the incident optical signal is required，Otherwise, its output voltage will be lower，Users need to find a balance between bandwidth and voltage。generally speaking，The detection pulse width is hundreds of nanoseconds、Picosecond or femtosecond laser pulse，The output of the detector needs to be connected in parallel50Ohm-100Ohmic resistance；If detector500usreach500nsLaser pulse，The detector output needs to be connected in parallel1k-10kOhmic resistance；If hundreds are detectedms-500usLaser pulse，The detector output needs to be connected in parallel10k-100kOhmic resistance；If the detection is greater than500msOr continuous laser，The detector output does not need parallel resistance，However, if the output voltage is high，Or to eliminate the influence of natural light，It can be connected in parallel appropriately100kResistance or potentiometer，One can reduce external noise，Second, the amplitude of the output voltage can be limited。

Bandwidth and response speed，Relationship between parallel resistance and voltage，You can refer to the English introduction on the picture above。

notes：Customizable detector with amplification，There are two types：A RF amplification （1MHz-100MHz）； B Weak signal amplification，Gain adjustable

 

7 Effective photosensitive diameter：300um

 

8 Supply voltage：5V-12V

 

9 The default is the detection mode of free space light entering the probe；If required by the user，It can be pasted in front of the probeFCflange，So that users can use it directlyFCOptical fiber head access detector。Please explain in advance when purchasing，Probes shipped by default do not come withFCflange

The flange so that the user can paste in front of the probe FC with optical fiber probe access directly